Front mudguard, brake shield (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the brake disc. See "Brake disc" in this section.

2. Remove the hub. See.

3. Remove the brake shield.

Installation procedure

1. Install the brake shield.

2. Secure the brake shield between the camshaft and the hub assembly.

3. Install the brake disc. See "Brake disc" in this section.

The text of the article was obtained from the website: «chevyman.ru»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Brake system

Front rotor, brake disc
Front Caliper Bracket
Front caliper — removal and installation
Front brake pads — removal and installation
Diagnosing Front Brake Faults

General description and operation of the rear brakes
Rear brake specifications
Rear Brake Fault Diagnosis
Rear brake pads — removal and installation
Rear Caliper — Removal and Installation

See similar articles on the topic of Chevrolet cars:
Front Disc Brake Specifications Chevrolet Aveo T250 (2006-2011)
Replacing the front wheel brake caliper assembly Chevrolet Cruze 1 (2008-2016)
Replacement of protective covers and sealing rings of pistons of brake cylinders of front and rear wheels Chevrolet Lacetti 1 (2002-2009)
Replacing the protective cover and sealing ring of the front wheel brake piston Chevrolet Lanos T150 (2002-2009)
Front brake device Chevrolet Niva 1 (2002-2016)
Location of front brake assemblies and units Chevrolet Tahoe 1 (1992-2000)
Replacing the front brake pads Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)