Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Raise and secure the vehicle.
2. Mark the position of the rear wheels relative to the hubs and remove the wheels. Follow section 2E, Tires and Wheels.
3. Remove the hollow bolt and O-rings used to install the brake hose to the caliper.
4. Disconnect the brake hose. Seal the hole in the caliper and the brake hose to prevent leakage and contamination of the brake fluid.
5. Remove the caliper guide pin bolts.
6. Remove the caliper.
Installation procedure
1. Install the caliper guide pin bolt.
Tighten
Tighten the caliper guide pin bolts to 44 N·m (32 lb-ft).
2. Attach the brake hose to the caliper using a hollow bolt and O-rings.
Tighten
Tighten the brake hose hollow bolt with O-rings to 44 N·m (32 lb-ft).
3. Install the rear wheels. Follow section 2E, Tires and Wheels.
4. Lower the car.
5. Fill the master cylinder reservoir with clean brake fluid to the proper level.
6. Remove air from the caliper. See Section 4A, Hydraulic Brakes.
(The text of the article was obtained from the website: «chevyman.ru»)