1. Remove the rear wheel from the side where the pads are being replaced.
2. Unscrew the bolt securing the brake hose tip to the caliper...
3. ...disconnect the brake hose and plug its hole.
4. Remove the parking brake cable from the pressure lever.
5. Press the cable housing clamps and remove the parking brake cable together with the housing from the bracket.
6. Unscrew the bolts securing the guide to the bracket and remove the caliper assembly.
7. Install the caliper in the reverse order of removal. When installing the brake hose, use only new copper washers. After installation, restore the brake fluid level in the master cylinder reservoir and bleed the air from the brake hydraulic drive (see "Bleeding the hydraulic brake system").