Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Raise and secure the vehicle.
2. Remove the rear wheels. Follow section 2E, Tires and Wheels.
3. Remove the brake caliper lower guide pin bolt.
Important: The caliper does not need to be removed to service the brake pads.
4. Turn the caliper upward.
5. Remove the brake pads.
Installation procedure
1. Measure the minimum thickness of the brake pads. See "General technical characteristics" in this section.
2. Install the pads back into place.
3. Push the piston in if necessary.
Note: Be careful not to damage the piston seal when lowering the caliper.
4. Turn the caliper down and install the bolt.
Tighten
Tighten the brake caliper lower guide pin bolt to 44 N·m (32 lb-ft).
5. Install the rear wheels. Follow section 2E, Tires and Wheels.
6. Lower the car.
The original material is located on the website «chevyman.ru»