Windscreen wiper system
The windshield wiper system consists of a windshield wiper motor, a linkage system, windshield wiper arms with brushes, and a wiper/washer switch. A return device consisting of a worm gear and a cam disk is installed in the windshield wiper circuit. The device serves to temporarily maintain the circuit in a closed state after the switch is switched to the off position. The windshield wiper system is driven by an electric motor with a permanent magnet. The windshield wiper motor is mounted on the front shield and is connected directly to the windshield wiper linkage system.
The windshield wiper motor has two speeds: LO (low) and HI (high), and is also capable of operating in intermittent mode. The wiper switch is an integral part of the wiper/washer switch. The windshield wipers are activated by a lever located on the right side of the steering column.
Windscreen washer system
The windshield washer system consists of a washer fluid reservoir, a washer fluid pump, hoses, jets and a wiper/washer switch. The windshield washer reservoir is mounted behind the front right wheel arch mudguard. Attached to the reservoir is a washer pump that supplies washer fluid through hoses to two jets mounted on the hood. The washer switch is an integral part of the wiper/washer switch. The windshield washers are activated by a lever located on the right side of the steering column.
Tightening torques for threaded connections
|
PROGRAM
|
Nm
|
pound-foot
|
pound-inch
|
|
Washer reservoir bolts
|
10
|
-
|
89
|
|
Windscreen wiper arm mounting nut
|
15
|
11
|
-
|
|
Windscreen wiper arm nut
|
22
|
16
|
-
|
|
Windscreen wiper motor bolts
|
10
|
-
|
89
|