Removal procedure
1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Disconnect the camshaft position sensor connector (SMR).
4. Remove the timing belt front cover. See Section 1C1, Engine Mechanical - FAM II 2.4D.
5. Remove the camshaft position sensor screws.
6. Remove the camshaft position sensor from the top.
Installation procedure
1. Install the camshaft position sensor with the bolts.
Tighten
Tighten the camshaft position sensor bolts to 8 Nm (71 lb-in).
2. Install the timing belt front cover. See Section 1C1, Engine Mechanical - FAM II 2.4D.
3. Connect the CMP sensor connector.
4. Install the engine cover.
5. Connect the negative battery cable.