We unscrew the nuts securing the brackets that support the parking brake cables on the rear suspension arms and remove them (see Removal the parking brake system components).
We remove the rubber stabilizer cushion from the beam.
Using a 17 mm open-end wrench, unscrew the stabilizer mounting bolt nut, holding the bolt from turning with a wrench of the same size…
…remove the nut with the washer and take out the bolt.
Similarly, we disconnect the stabilizer mount on the other side of the beam.
Using a soft metal mandrel, we strike the end of the stabilizer with a hammer.
On the other side of the car, using an impact puller with a hook-shaped tip, we remove the stabilizer from the beam.
We install the anti-roll bar in the reverse order.
(The article is based on data from the website «CHEVYMAN.ru»)