Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Rear window trim (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the screws from the rear window trim.

2. Remove the rear window trim.

2. Remove the rear window trim.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the rear window trim and tighten the screws.

Tighten

Tighten the rear window trim screws to 1.3 Nm (12 lbs.in).

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Doors and windows

Next articles

Front window trim
External window sealing strip
Diagnostics of locks and electric windows
Schematic diagrams of locks and electric windows
General description and operation of doors

Front door groove
Rear door groove
Door seal
Front door glass seal
Rear door glass seal

See similar articles on the topic of Chevrolet cars:
Removal and installation the rear door trim Chevrolet Aveo T300 (2012-2018)
Removal and installation the rear door trim Chevrolet Cruze 1 (2008-2016)
Wiring diagram for windshield and rear window wipers and washers (hatchback and station wagon, without rain sensor) Chevrolet Lacetti 1 (2002-2009)
Rear window heating circuit diagram Chevrolet Lanos T150 (2002-2009)
Rear window cleaner Chevrolet Niva 1 (2002-2016)
Rear Hinged Window (Sport-Utility Models) — Removal and Installation Chevrolet Tahoe 1 (1992-2000)
Checking and repairing the rear window defroster Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.