1. Disconnect the wire from the negative terminal of the battery.
2. Using a screwdriver, pry off the cover of the screw securing the upholstery under the armrest...
3. ...and remove the screw.
4. Pry up the plug located in the trim of the inner door lock handle and remove the plug...
5. ...then unscrew the trim mounting screw located under the plug.
6. Pry up the edges of the upholstery and remove the eight pins (figure 11.2) from engagement with the door panel.
7. Lift up the front edge of the door trim until the lock release button comes out of the hole in the trim and move the trim away from the door panel.
8. Press the latch of the inner door lock handle cable sheath end and disconnect the cable sheath from the inner handle bracket.
9. Turn the cable end and disconnect it from the inside door lock handle.
10. Squeeze the retainer and disconnect the wiring harness connector from the power window control switch, then remove the rear door trim.
11. Install the rear door trim and all removed parts in the reverse order of removal.