Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Lumbar support handle (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the lumbar support handle.

1. Remove the lumbar support handle.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the lumbar support handle.

The article is reprinted from the website «ChevyMan»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Car seat

Next articles

Seat tilt lever
Driver's seat sliding unit with electric drive
Front seat base
Front seat cushion
Front seat back

Height adjustment lever
Front seat trim
Seat headrest — removal and installation
Rear seat — removal and installation
Rear seat upholstery

See similar articles on the topic of Chevrolet cars:
Replacing the left support of the powertrain suspension Chevrolet Aveo T300 (2012-2018)
Replacing the upper support of the front suspension shock absorber strut Chevrolet Cruze 1 (2008-2016)
Removal the inside front door handle Chevrolet Lacetti 1 (2002-2009)
Removal and installation the gearbox and transfer case handle inserts for the 55 configuration Chevrolet Niva 1 (2002-2016)
Middle support of the propeller shaft — removal and installation Chevrolet Tahoe 1 (1992-2000)
Latch, Lock Cylinder and Door Handle — Removal and Installation Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.