Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Height adjustment lever (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the height adjustment lever.

1. Remove the height adjustment lever.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the height adjustment lever.

[The original source of the article is the website: «chevyman.ru»]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Car seat

Next articles

Lumbar support handle
Seat tilt lever
Driver's seat sliding unit with electric drive
Front seat base
Front seat cushion

Front seat trim
Seat headrest — removal and installation
Rear seat — removal and installation
Rear seat upholstery
Backrest of the rear seat

See similar articles on the topic of Chevrolet cars:
Headrest height adjustment Chevrolet Aveo T200 (2003-2008)
Removal and installation the gearbox control lever joint Chevrolet Cruze 1 (2008-2016)
Removal the lever Chevrolet Lacetti 1 (2002-2009)
Removal the lever Chevrolet Lanos T150 (2002-2009)
Main adjustment and control parameters Chevrolet Niva 1 (2002-2016)
Moving the gear lever to PARK (P) Chevrolet Tahoe 1 (1992-2000)
General information on adjustment Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.