Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Assembly of the downshift brake piston (B4) (Chevrolet Captiva 1)

1. Install the downshift brake piston (B4).

Install piston B4 as shown in the figure.
Lubricate the new sealing ring with automatic transmission fluid and install it in the groove of piston B4.

Lubricate the new sealing ring with automatic transmission fluid and install it in the groove of…

Using needle-nose pliers, install the locking clip into the groove of the piston rod B4.

Using needle-nose pliers, install the locking clip into the groove of the piston rod B4.

The original text can be found on the website: chevyman

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Automatic gearbox - repair

Next articles

Disassembling the downshift brake piston (B4)
Assembly of the underdrive clutch (C3)
Checking the underdrive clutch (C3)
Disassembling the underdrive clutch (C3)
Checking the operation of overrunning clutch No. 2 (F2)

Disassembling the valve block
Checking the valve block
Valve block assembly

See similar articles on the topic of Chevrolet cars:
Brake problems Chevrolet Aveo T300 (2012-2018)
Brake problems Chevrolet Cruze 1 (2008-2016)
Checking the fluid level in the brake and clutch hydraulic reservoir Chevrolet Lacetti 1 (2002-2009)
Replacing the protective cover and sealing ring of the front wheel brake piston Chevrolet Lanos T150 (2002-2009)
Brake system Chevrolet Niva 1 (2002-2016)
Brake fluid and pads Chevrolet Tahoe 1 (1992-2000)
Brake inspection (every 7,500 miles or 12 months) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.