Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Valve block assembly (Chevrolet Captiva 1)

1. Install shift solenoid valves SS1, SS2, SS3, SS4 and SS5.

Replace the sealing rings of all solenoid valves and install 5 solenoid valves.

Replace the sealing rings of all solenoid valves and install 5 solenoid valves.

Important: Be sure to use new O-rings, not damaged ones.

2. Tighten the 5 bolts securing each solenoid valve.

Tighten

Tighten the solenoid valve mounting bolt to 7 Nm (62 lbs.in).

Tighten the solenoid valve mounting bolt to 7 Nm (62 lbs.in).

Tighten the solenoid valve mounting bolt to 7 Nm (62 lbs.in).

3. Install the range selector valve.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Automatic gearbox - repair

Next articles

Checking the valve block
Disassembling the valve block
Assembly of the downshift brake piston (B4)
Disassembling the downshift brake piston (B4)
Assembly of the underdrive clutch (C3)

See similar articles on the topic of Chevrolet cars:
Replacing valve stem seals Chevrolet Aveo T300 (2012-2018)
Replacing valve stem seals Chevrolet Cruze 1 (2008-2016)
Removal camshafts and hydraulic valve lifters Chevrolet Lacetti 1 (2002-2009)
Removal the idle speed control valve Chevrolet Lanos T150 (2002-2009)
Control lamp block Chevrolet Niva 1 (2002-2016)
Left half-block valve cover Chevrolet Tahoe 2 and 3 (2000-2014)
Check and replace PCV valve (every 30,000 miles or 24 months) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.