Fig. 8.3. Power steering pump: 1 - pump pulley; 2 - pump mounting bolt hole; 3 - pump body; 4 - rear cover of the pump housing; 5 - high pressure pipeline branch pipe; 6 - liquid supply hose branch pipe
You will need: a 22 mm wrench and pliers.
1. Remove the power steering pump drive belt by cutting it with a knife (see "Checking and replacing the power steering pump drive belt").
2. Loosen the clamp securing the fluid supply hose to the power steering pump pipe by squeezing the bent ears with pliers. Slide the clamp along the hose...
3. ...and disconnect the hose from the branch pipe.
4. Unscrew the bolt-fitting the high-pressure line to the nipple of the power steering pump...
5. ...and disconnect the pipeline.
6. Remove the two power steering pump mounting bolts from the exhaust manifold side.
7. Remove the pump.
8. Install the power steering pump in the reverse order of removal.
9. Fill the power steering system with fluid and bleed air from it (see "Replacing the working fluid and bleeding the power steering system").
The source of the article is available on the website chevyman