Removal and installation the windshield washer hose (Chevrolet Tahoe 2)

1. Open the hood.

2. Remove the left front fender liner.

3. Disconnect the washer hose from the electric pump.

4. Disconnect the clamps (1).

5. Disconnect washer hose No.1 (2) from washer hose No.2.

6. Install in the reverse order of removal.

(The original source of the article is the website: «ChevyMan»)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (since 2007)

Removal and installation the windshield wiper control switch
Removal and installation the switch panel
Removal and installation the watch
Removal and installation the trip computer control switch
Removal and installation the instrument cluster

Removal and installation the washer reservoir
Removal and installation the windshield washer electric pump
Removal and installation the rear window washer electric pump
Removal and installation the washer fluid level sensor
Removal and installation the washer fluid heater

See similar articles on the topic of Chevrolet cars:
Checking the level and adding fluid to the washer reservoir Chevrolet Aveo T300 (2012-2018)
Windshield washer jets Chevrolet Captiva 1 (2006-2018)
Checking the level and adding fluid to the washer reservoir Chevrolet Cruze 1 (2008-2016)
Checking the fluid level in the windshield washer reservoir Chevrolet Lacetti 1 (2002-2009)
Checking the fluid level in the windshield washer reservoir Chevrolet Lanos T150 (2002-2009)
Washer fluid Chevrolet Niva 1 (2002-2016)
Removal and installation the windshield wiper and washer switch Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)