Removal and installation fog lights (Chevrolet Tahoe 2)

1. Remove the bolt (2) from the fog light mounting bracket. Tightening torque 25 Nm.

2. Disconnect the connector from the fog light.

3. Remove the fog light (1).

4. Install in the reverse order of removal.

(The original material is located on the website chevyman.ru)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Lighting and lamps (until 2007)

Removal and installation the combination lamp
Front direction indicator and front side light (Avalanche)
Removal and installation the front turn signal
Adjusting fog lights
Replacing bulbs in fog lights

Replacing the fog light bulb
Removal and installation an additional brake light
Removal and installation the license plate light
Removal and installation the engine compartment light
Removal and installation the door opening illumination lamp

See similar articles on the topic of Chevrolet cars:
Replacing license plate lights Chevrolet Aveo T300 (2012-2018)
Front fog lights Chevrolet Captiva 1 (2006-2018)
Wiring diagram for fog lights and fog lamps in the rear lights Chevrolet Lacetti 1 (2002-2009)
Wiring diagram for fog lights and fog light bulb in left rear light Chevrolet Lanos T150 (2002-2009)
Rear fog lights on/off control Chevrolet Niva 1 (2002-2016)
Main and fog lights — adjustment Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)