8. To access the rear blower motor, remove the side trim panel (see chapter 11, section 12).
9. To remove the supercharger, follow the sequence illustrated in the photographs, remembering to read the accompanying labels. To separate the fan from the electric motor, unscrew the motor shaft nut (see illustration 10.5).
10.9a. Remove the lower air duct mounting bolts, the lower rear evaporator bolt and the fan bolt (indicated by arrows) |
10.9b. Remove the cover from the electrical connector and disconnect it (indicated by the left arrow). Remove the upper rear evaporator and blower motor bolt (right arrow) |
10.9v. Using a small screwdriver, pry the rear evaporator and blower away from the lower air duct |
10.9g. To remove the blower fan, unscrew the front cover screw (indicated by the arrow)... |
10.9d....and the screws for fastening the back cover (indicated by arrows) and remove the knot |
10.5. Unscrew the nut (indicated by the arrow) from the motor shaft and pull out the fan (the nut is unscrewed clockwise) |
10. Installation is carried out in reverse order.
[The article was borrowed from the website CHEVYMAN.RU]