Contents: Removal procedure ↧ Installation procedure ↧
Necessary equipment
Glass Seal Remover J-24402
Removal procedure
1. Remove the windshield trim molding. See section 9R, "Front Body Part".
2. Remove the interior rearview mirror. See "Interior rearview mirror" in this section.
3. Remove the seal around the windshield.
4. Use the J-24402 Glass Seal Remover to trim the adhesive around the windshield.
5. Use a knife to remove the adhesive from the windshield.
6. Use a knife to remove the adhesive from the windshield frame.
7. Remove the windshield from the vehicle.
Installation procedure
1. Install a new seal on the windshield.
2. Apply tape to the new seal and windshield to hold the seal in place.
3. Apply adhesive primer to the windshield frame and around its perimeter.
4. Apply glass adhesive to the windshield frame.
5. Install the windshield into the frame.
6. Reinstall the tape onto the weatherstrip, windshield and frame to hold the windshield in place.
7. Allow the glue to dry for 24 hours.
8. Remove the tape.
9. Check for water leaks by pouring water on the windshield. If a leak is detected, dry the windshield and fill the leak area with glue. If the leak cannot be eliminated, remove the windshield and repeat the entire procedure.
10. Install the interior rearview mirror. See "Interior rearview mirror" in this section.
11. Install the windshield trim molding. See section 9R, "Front Body Part".
The material was created based on information from the website: «CHEVYMAN.ru»