Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Remove the pins securing the brake fluid reservoir to the master cylinder and remove the fluid level sensor by pressing on its support.
2. Disconnect the reservoir from the master cylinder.
3. Close the open brake fluid reservoir to prevent fluid spillage and contamination of the environment.
Installation procedure
1. Lubricate the new brake fluid reservoir seals with clean brake fluid.
2. Install the brake fluid reservoir seals into the master cylinder body.
3. Install the brake fluid reservoir mounting pins to the master cylinder and the fluid level sensor.
4. Add brake fluid.
5. Raise and secure the vehicle.
6. Bleed the brake system. See Part 4A. Hydraulic brakes.
7. Lower the car.
[The article is based on data from the website chevyman.ru]