Power steering controller for variable speed-dependent power steering (SSPS) (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Disconnect the negative battery cable.

2. Remove the driver's knee bolster See section 9G, "Interior Trim".

3. Disconnect the SSPS controller connector.

4. Remove the SSPS controller from the bracket by sliding the controller upward.

5. If necessary, remove the bracket by unscrewing the mounting bolts.

Installation procedure

1. Install the controller bracket using bolts.

Tighten

Tighten the SSPS controller bracket bolts to 10 N·m (7 ft·lbs).

2. Install the SSPS controller onto the bracket.

3. Connect the SSPS controller connector.

4. Install the driver's knee bolster. See section 9G, "Interior Trim".

5. Connect the negative battery cable.

The article is reprinted from the website: ChevyMan

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Steering

Hydraulic cylinder pipelines
Intermediate shaft, hinge and front panel seal
Checking the straight-ahead position of the steering wheels
Steering gear boot
External transverse tie rod

General description and operation of the steering column
Diagnosing steering column faults
Steering column cover
Turn signal/headlight switch and lever
Windscreen wiper/cruise control lever and switch