Rear stabilizer bar insulator (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Raise and support the vehicle.

2. Remove the stabilizer bar clamp bolts.

3. Remove the insulators from the stabilizer bar.

Installation procedure

1. Install insulators on the stabilizer bar.

2. Install the stabilizer bar clamp bolts.

Tighten

Tighten the bolts to a torque of 70 Nm (52 ft·lbs).

3. Lower the car.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Car suspension

Rear stabilizer bar
Lower arm rear suspension
Upper arm rear suspension
Rear suspension knuckle
Rear suspension support

Rear stabilizer bar connecting link
Rear suspension shock absorber
Rear Coil Spring/Isolators
Rear suspension trailing arm
Trailing arm bracket

See similar articles on the topic of Chevrolet cars:
Rear view mirrors Chevrolet Aveo T300 (2012-2018)
Rear view mirrors Chevrolet Cruze 1 (2008-2016)
Replacing the rear crankshaft oil seal Chevrolet Lacetti 1 (2002-2009)
Rear view mirrors Chevrolet Lanos T150 (2002-2009)
Rear fog lights on/off control Chevrolet Niva 1 (2002-2016)
Rear suspension stabilizer bar Chevrolet Tahoe 2 and 3 (2000-2014)
Replacing the rear crankshaft oil seal Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)