Removal and installation of the stabilizer bar
Withdrawal
1. Raise the vehicle and place the safety stands under the frame.
2. Turn away a nut of a spherical support of draft of the stabilizer. Tightening torque 65 Nm.
3. Turn away bolts of fastening of an arm of pillows of the stabilizer. Tightening torque 33 Nm.
4. Remove the stabilizer.
Installation
5. Installation is carried out in the reverse order.
Note:
- The orientation of the stabilizer link ball joint is shown in the figure.
- The cut in the stabilizer pad must face forward.
Replacement of pillows of the stabilizer
When replacing the stabilizer pads, there is no need to remove the anti-roll bar itself.
Turn away bolts of fastening of an arm of pillows of the stabilizer and take a pillow.
Note: the pillow has a split design.