Assembly order
1. Install the angle disc (4) on the gear shift rod (5).
2. Install the 1st/2nd gear pressure spring (3).
3. Install the inner spring seat (2).
4. Install new retaining rings (1).
5. Install the gear shift cover (4).
6. Install the vent cover (3).
7. Install the shift control lever (1).
8. Install a new roll pin (2).
9. Install the 5th gear/reverse pressure spring (1).
10. Install the outer spring seat (2).
11. Install the gear selector lever latch (3) into the gear selector lever pin (4).
Important: Correctly support the selector lever pin (4) when installing the roll pin. Do not support the selector lever pin (4) with the selector lever latch (3).
12. Install a new roll pin (5).
13. Install a new roll pin (6).
[The original material is located on the website ChevyMan]