Cleaning and checking the synchronizer (Chevrolet Captiva 1)

1. Clean the synchronizer with cleaning solvent.

2. Dry the components with a stream of air.

3. Check the synchronizer teeth for the following conditions:

wear
Jamming
Dents
Bullies
Destruction

4. Check the crackers or springs for the following conditions:

wear
Cracks
Deformation
Replace the synchronizer if the following conditions occur.

Replace the synchronizer if the following conditions occur.

For details, visit the website chevyman.ru

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Manual gearbox - service and repair

Cleaning and checking the thrust ring and bearing
Cleaning and checking gears
Cleaning and checking the clutch housing and the gearbox housing with the final drive assembly
Disassembling the secondary shaft
Disassembling the primary shaft

Cleaning and checking the gear shift fork
Secondary shaft assembly
Primary shaft assembly
Intermediate shaft assembly
Gear shift shaft assembly

See similar articles on the topic of Chevrolet cars:
Checking the brake system Chevrolet Aveo T300 (2012-2018)
Checking the wheels Chevrolet Cruze 1 (2008-2016)
Checking the condition of wheels and tires Chevrolet Lacetti 1 (2002-2009)
Checking the condition of wheels and tires Chevrolet Lanos T150 (2002-2009)
Checking the engine on a car after repair Chevrolet Niva 1 (2002-2016)
Automatic transmission drive clutch — cleaning and checking Chevrolet Tahoe 2 and 3 (2000-2014)
Cleaning and checking the cylinder head Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)