Rear cargo compartment door lock actuator (Chevrolet Tahoe 2)

Removal

1. Remove the upper and lower door trim panels.

2. Disconnect the door wiring connectors.

3. Disconnect the lock control cables from the drive.

4. Unscrew the bolts securing the lock drive.

4. Unscrew the bolts securing the lock drive.

5. Remove the drive from the door.

6. Remove the lock cylinder.

Installation

1. Install the door lock cylinder.

2. Install the drive on the door.

3. Tighten the drive mounting bolts by hand.

4. Close the door window glass, the drive position will be adjusted automatically.

5. Connect the control cables to the drive, tighten the drive mounting bolts. Tightening torque 9 N·m.

6. Connect the wiring connectors.

7. Install the top and bottom trim panels.

The original article can be found on the resource: CHEVYMAN.RU

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Doors, locks and windows

Rear cargo door glass
Rear cargo door trim panel
Rear cargo door (one piece)
Cargo compartment door (composite)
Glass guide channel

Rear cargo door lock cylinder
Rear door lock
Fuel tank filler flap
Pressure relief valve
Rear side of the cargo compartment