Contents: Removal ↧ Installation ↧
Removal
1. Partially raise the glass.
2. On the front door, remove the upper door trim panel extension.
3. Remove the manual door lock lever.
4. Remove the window lift handle (if installed).
5. Remove the door control unit switch panel (if installed).
6. Remove the door trim panel.
7. Remove the door seal.
8. Loosen the front glass guide channel mounting bolt. Tightening torque 9 Nm.
9. Loosen the two bolts (2). There may only be one bolt on the rear door. Tightening torque 12 Nm.
Warning: Do not remove the bolts completely.
10. Remove the glass (3) by moving it upwards and outwards.
Front door
Rear Side Door - Suburban / Yukon XL / Avalanche
Rear Side Door - Tahoe / Yukon / Escalade
Installation
11. Installation is carried out in the reverse order. After installation, check the operation of the window lifter.