Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Tahoe 2 and 3 (2000-2014) Tahoe 1 (1992-2000)

Removal and installation the light sensor (Chevrolet Tahoe 2)

1. Remove the upper instrument panel trim.

2. Disconnect the connector (1) from the sensor.

2. Disconnect the connector (1) from the sensor.

3. Turn the sensor a quarter turn and remove it.

4. Install in the reverse order of removal.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Tahoe 2 and 3: Lighting and lamps (until 2007)

Next articles

Removal and installation the headlight corrector switch
Removal and installation the brake light switch
Removal and installation the fog light switch
Fog light and interior light switch
Removal and installation the fog light switch

Removal and installation the turn signal relay
Removal and installation daytime lighting system relay
Removal and installation headlights
Removal and installation of gas discharge headlights
Removal and installation fog lights

See similar articles on the topic of Chevrolet cars:
Replacing the oil pressure warning light sensor Chevrolet Aveo T300 (2012-2018)
Emergency light signaling Chevrolet Captiva 1 (2006-2018)
Replacing the pressure sensor Chevrolet Cruze 1 (2008-2016)
Removal the low oil pressure sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Adjusting the position of the brake light switch Chevrolet Niva 1 (2002-2016)
Brake light sensor — checking functionality and replacement Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.