Auxiliary handrails for the passenger (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Open the screws of the auxiliary handrail.

2. Remove the screws and auxiliary grab handle from the headliner.

Installation procedure

Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.

1. Install the auxiliary grab handle to the headliner using screws.

Tighten

Tighten the screws of the passenger side auxiliary grab handle to 3 Nm (27 lbs.in).

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Doors and windows

Sun visors with vanity mirror
Shaped upholstery of the passenger compartment ceiling
Electric sunroof
Sunroof Fault Diagnosis
Schematic diagrams of the sunroof with electric drive

Electric sunroof control switch
Rear drop door
Rear Tailgate Pillar
Rear Tailgate Latch
Rear Tailgate Latch Lock

See similar articles on the topic of Chevrolet cars:
Replacement of auxiliary drive belts Chevrolet Aveo T300 (2012-2018)
Heating (air conditioning) and ventilation of the passenger compartment Chevrolet Cruze 1 (2008-2016)
Replacement of auxiliary drive belt Chevrolet Lacetti 1 (2002-2009)
Adjusting the tension of the auxiliary drive belt Chevrolet Niva 1 (2002-2016)
Side locking window (extended cab passenger/cargo models) — removal and installation Chevrolet Tahoe 1 (1992-2000)
Starting the engine from an auxiliary battery Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)