Contents: Removal procedure ↧ Installation procedure ↧
Removal procedure
1. Remove the decorative door seal trim. See section 9P, "Doors".
2. Remove the rear side door glass frame trim. See section 9M, "Exterior Finishing".
3. Remove the screws securing the glass to the window regulator.
4. Remove the glass from the door.
Installation procedure
1. Install the glass into the door and place the glass into the window lifter.
Note: Direct contact of dissimilar metals may result in rapid corrosion. Use proper fasteners to avoid premature corrosion.
2. Install glass screws.
Tighten
Tighten the glass screws to 1.3 Nm (12 lbs.in).
3. Install the rear side door glass frame rear trim. See section 9M, "Exterior Finishing".
4. Install the door seal trim. See section 9P, "Doors".
The original article is on the website: «chevyman.ru»