Boost Pressure Sensor (T-MAP Sensor) (Chevrolet Captiva 1)

Removal/installation procedure

1. Disconnect the negative battery cable.

2. Remove the decorative cover. See Section 1B, "Engine Mechanical System - 2.0 Diesel".

3. Disconnect the boost pressure sensor connector.

4. Remove the engine wiring harness cover upward.

5. Remove the boost pressure sensor.

Tighten

Tighten the boost pressure sensor bolt to 8 Nm (70.8 lbs.in).

Tighten the boost pressure sensor bolt to 8 Nm (70.8 lbs.in).

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Control and power systems

Vacuum pump
Camshaft Position (CMP) Sensor
Electronic Throttle Control (ETC)
Mass Air Flow (MAF) Sensor
Accelerator Pedal (APM)

Coolant Temperature Sensor (ECTS)
Crankshaft Position Sensor (CKP)
Oil pressure sensor
Exhaust Gas Recirculation Vacuum Solenoid Valve
Exhaust Gas Recirculation (EGR) System

See similar articles on the topic of Chevrolet cars:
Absolute pressure (vacuum) sensor in the intake manifold Chevrolet Aveo T300 (2012-2018)
Replacing the pressure sensor Chevrolet Cruze 1 (2008-2016)
Removal the low oil pressure sensor Chevrolet Lacetti 1 (2002-2009)
Checking the Manifold Absolute Pressure Sensor Chevrolet Lanos T150 (2002-2009)
Checking the performance of the pressure regulator Chevrolet Niva 1 (2002-2016)
Fuel tank pressure sensor Chevrolet Tahoe 2 and 3 (2000-2014)
Manifold Absolute Pressure (MAP) Sensor — Replacement Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)