Vacuum pump (Chevrolet Captiva 1)

Removal procedure

1. Remove the negative battery cable.

2. Remove the decorative cover. See Section 1B, "Engine Mechanical System - 2.0 Diesel".

3. Loosen the bolts of the connection block. See "Fuel return line assembly" in this section.

4. Remove the decorative cover bracket.



5. Remove the engine wiring harness bracket.

6. Disconnect the EGR and brake booster vacuum hoses.



7. Remove the vacuum pump.

Installation procedure

1. Install the vacuum pump.

Tighten

Tighten the vacuum pump clamp bolts to 12 Nm (8.9 ft·lbs).



2. Install the engine wiring harness bracket.

3. Connect the exhaust gas recirculation and brake booster vacuum hoses.

Tighten

Tighten the engine wiring harness bracket nuts to 20 N·m (14.8 ft·lbs).



4. Install the decorative cover bracket.

Tighten

Tighten the decorative cover bracket bolts to 11 Nm (97.4 lbs.in).