Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Captiva 1 (2006-2018)

Coolant Temperature Sensor (ECTS) (Chevrolet Captiva 1)

Removal/installation procedure

1. Disconnect the negative battery cable.

2. Remove the decorative cover. See Section 1B, "Engine Mechanical System - 2.0 Diesel".

2. Remove the decorative cover. See Section 1B, «Engine Mechanical System - 2.0 Diesel».

3. Disconnect the ECT sensor connector.

4. Remove the coolant temperature sensor.

Tighten

Tighten the ECT sensor to 35 Nm (25.8 ft·lbs).

Tighten the ECT sensor to 35 Nm (25.8 ft·lbs).

The text of the article was obtained from the website «CHEVYMAN»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Captiva 1: Control and power systems

Next articles

Boost Pressure Sensor (T-MAP Sensor)
Vacuum pump
Camshaft Position (CMP) Sensor
Electronic Throttle Control (ETC)
Mass Air Flow (MAF) Sensor

Crankshaft Position Sensor (CKP)
Oil pressure sensor
Exhaust Gas Recirculation Vacuum Solenoid Valve
Exhaust Gas Recirculation (EGR) System
Removal and installation a turbocharger

See similar articles on the topic of Chevrolet cars:
Coolant temperature sensor Chevrolet Aveo T300 (2012-2018)
Scheme 8. Absolute pressure and coolant temperature sensors Chevrolet Cruze 1 (2008-2016)
Removal the coolant temperature sensor Chevrolet Lacetti 1 (2002-2009)
Checking the coolant temperature sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Filling the cooling system with coolant Chevrolet Niva 1 (2002-2016)
Coolant temperature sensor Chevrolet Tahoe 2 and 3 (2000-2014)
Checking and replacing the coolant temperature sensor Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.