Oil pressure sensor (Chevrolet Captiva 1)

Removal/installation procedure

1. Disconnect the negative battery cable.

2. Drain the engine oil.

3. Disconnect the oil pressure sensor connector.

4. Remove the oil pressure sensor.

Tighten

Tighten the oil pressure sensor to 30 Nm (22.1 ft·lbs).

Tighten the oil pressure sensor to 30 Nm (22.1 ft·lbs).

(The article is based on data from the website: «CHEVYMAN»)

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Control and power systems

Crankshaft Position Sensor (CKP)
Coolant Temperature Sensor (ECTS)
Boost Pressure Sensor (T-MAP Sensor)
Vacuum pump
Camshaft Position (CMP) Sensor

Exhaust Gas Recirculation Vacuum Solenoid Valve
Exhaust Gas Recirculation (EGR) System
Removal and installation a turbocharger
Glow plug
Exhaust Gas Temperature (EGT) Sensor 1

See similar articles on the topic of Chevrolet cars:
Absolute pressure (vacuum) sensor in the intake manifold Chevrolet Aveo T300 (2012-2018)
Replacing the pressure sensor Chevrolet Cruze 1 (2008-2016)
Removal the low oil pressure sensor Chevrolet Lacetti 1 (2002-2009)
Checking the Manifold Absolute Pressure Sensor Chevrolet Lanos T150 (2002-2009)
Checking the performance of the pressure regulator Chevrolet Niva 1 (2002-2016)
Fuel tank pressure sensor Chevrolet Tahoe 2 and 3 (2000-2014)
Manifold Absolute Pressure (MAP) Sensor — Replacement Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)