Crankshaft Position Sensor (CKP) (Chevrolet Captiva 1)

Removal/installation procedure

1. Disconnect the negative battery cable.

2. Disconnect the crankshaft position sensor connector.

3. Remove the CKP sensor.

Tighten

Tighten the crankshaft position sensor mounting screw to 7 Nm (62 lbs.in).

Tighten the crankshaft position sensor mounting screw to 7 Nm (62 lbs.in).

The text of the article was obtained from the website: «ChevyMan»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Control and power systems

Coolant Temperature Sensor (ECTS)
Boost Pressure Sensor (T-MAP Sensor)
Vacuum pump
Camshaft Position (CMP) Sensor
Electronic Throttle Control (ETC)

Oil pressure sensor
Exhaust Gas Recirculation Vacuum Solenoid Valve
Exhaust Gas Recirculation (EGR) System
Removal and installation a turbocharger
Glow plug

See similar articles on the topic of Chevrolet cars:
Engine Crankshaft Position Sensor Chevrolet Aveo T300 (2012-2018)
Adjusting the position of the front seats Chevrolet Cruze 1 (2008-2016)
Removal the crankshaft position sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Adjusting the position of the steering wheel Chevrolet Niva 1 (2002-2016)
Crankshaft position sensor Chevrolet Tahoe 2 and 3 (2000-2014)
Crankshaft Position Sensor (for 3.8L engine) Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)