Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Tahoe 2 and 3 (2000-2014) Tahoe 1 (1992-2000)

Bracket for support of bumper trim panel (Chevrolet Tahoe 2)

Contents: Removal ↧ Installation ↧

Removal

1. Remove the front bumper trim panel.

2. Loosen the six bolts (1) securing the support bracket (2). Tightening torque 7 Nm.

2. Loosen the six bolts (1) securing the support bracket (2). Tightening torque 7 Nm.

3. Disconnect the wiring connectors from the bracket.

3. Disconnect the wiring connectors from the bracket.

4. Remove the bracket.

Installation

5. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Tahoe 2 and 3: Exterior (external elements)

Next articles

Front Bumper Lower Trim (Z71)
Front bumper trim panel

Front bumper trim panel reinforcement
Front bumper reinforcement
Front bumper reinforcement support
Rear bumper trim panel
Rear bumper reinforcement

See similar articles on the topic of Chevrolet cars:
Front door trim panel Chevrolet Aveo T250 (2006-2011)
Rear wheel arch trim panel Chevrolet Captiva 1 (2006-2018)
Replacing the upper support of the front suspension shock absorber strut Chevrolet Cruze 1 (2008-2016)
Removal the lower instrument panel trim Chevrolet Lacetti 1 (2002-2009)
Removal the front bumper Chevrolet Lanos T150 (2002-2009)
Instrument panel Chevrolet Niva 1 (2002-2016)
Removal and installation the heater and air conditioner control panel Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.