Home Aveo Captiva Cruze Lacetti Lanos Niva Tahoe Others

Tahoe 2 and 3 (2000-2014) Tahoe 1 (1992-2000)

Front bumper trim panel reinforcement (Chevrolet Tahoe 2)

Contents: Removal ↧ Installation ↧

Removal

1. Remove the front half of the front wheel arch liner.

2. Unscrew the four bolts (1) securing the amplifier (2). Tightening torque 7 Nm.

2. Unscrew the four bolts (1) securing the amplifier (2). Tightening torque 7 Nm.

3. Remove the amplifier.

Installation

4. Installation is carried out in reverse order.

The article is based on data from the website: chevyman

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Previous articles

Tahoe 2 and 3: Exterior (external elements)

Next articles

Bracket for support of bumper trim panel
Front Bumper Lower Trim (Z71)
Front bumper trim panel

Front bumper reinforcement
Front bumper reinforcement support
Rear bumper trim panel
Rear bumper reinforcement
Radiator grille — removal and installation

See similar articles on the topic of Chevrolet cars:
Front door trim panel Chevrolet Aveo T250 (2006-2011)
Front bumper trim Chevrolet Captiva 1 (2006-2018)
Removal and installation the front bumper Chevrolet Cruze 1 (2008-2016)
Removal the front bumper Chevrolet Lacetti 1 (2002-2009)
Removal the front bumper Chevrolet Lanos T150 (2002-2009)
Installation of beam and front bumper for assembly 55 Chevrolet Niva 1 (2002-2016)
Instruments and controls on the front panel and console Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)

🛡️ For your security and to improve our service, this site uses cookies. You can disable them in your browser.