Removal and installation the brake pedal position sensor (Chevrolet Tahoe 2)

1. Remove the knee support.

2. Remove the mounting block cover.

3. Disconnect the connector (1).

4. Loosen the bolts (2). Tightening torque 9 Nm.

5. Remove the brake pedal position sensor (3).

6. Install in the reverse order of removal.

The original source of the article is the website: «CHEVYMAN.RU»

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Lighting and lamps (since 2007)

Removal and installation the brake light switch

Removal and installation the lighting control switch
Removal and installation the light sensor
Removal and installation the interior lighting lamp
Removal and installation the local lighting lamp
Removal and installation the footrest lighting lamp

See similar articles on the topic of Chevrolet cars:
Checking the brake pedal position Chevrolet Aveo T300 (2012-2018)
Clutch pedal position sensor Chevrolet Captiva 1 (2006-2018)
Scheme 24. Steering wheel angular displacement sensors, accelerator pedal position sensors and ABS hydro-electronic module Chevrolet Cruze 1 (2008-2016)
Removal the crankshaft position sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Adjusting the position of the brake light switch Chevrolet Niva 1 (2002-2016)
Brake pedal position sensor Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)