Rear suspension toe arm (Chevrolet Captiva 1)

Removal procedure

1. Raise and support the vehicle.

2. Remove the nut and bolt securing the toe-in lever to the steering knuckle.



3. Remove the nut and bolt securing the toe-in lever to the support.

4. Remove the toe arm from the vehicle.

Installation procedure

1. Install the toe arm assembly onto the support.

Important:

• Install the bolt with the head facing the front of the vehicle.
• Move the cam nut to the same position as the upper control arm.

2. Install the toe-in lever onto the steering knuckle.



Tighten

Tighten the bolt to a torque of 160 Nm (118 ft·lbs).

3. Tighten the toe-in lever mounting bolt to the support.

Tighten

Tighten the bolt to a torque of 160 Nm (118 ft·lbs).

4. Lower the car.

5. Check the rear wheel alignment. See Part 2B. Wheel alignment.

[The original article can be found on the resource: ChevyMan.ru]