General information
The permissible thickness of the friction disc linings is 1.5
Tightening torques for connections (Nm)
Clutch
Bolts securing the pressure plate to the flywheel:
- 5/16-inch bolts-15-22
- 3/8-inch bolts-26-37
Clutch release lever ball shaft - 30
Bolts for fastening the bell housing to the engine (Gearbox with cast iron crankcase) — 67
Master Cylinder Fastening Nuts - 16
Clutch slave cylinder mounting bolts:
- Before 1995 - 16
- Since 1996 - 8
Cardan shaft
Eye bolts:
- Cars 0.5-0.75 T — 18
- Cars 1 T - 32
Center support bearing mounting nuts - 30
Rear axle
Brake shield bolts
- axle with differential driven gear diameter 8+1/2 inches - 42
- axle with differential driven gear diameter 9+1/2 inches - 130
Bolts for fastening the axle shaft to the hub ("floating" axle) - 140
Differential locking mechanism bolt - 32
Front driving axle (all-wheel drive models)
Hub Nut:
- Before 1994 - 210
- 1995 — 216
- From 1996 - 200
Flange mounting bolts - 72
General information
This Chapter covers the procedure for dismantling and repairing the clutch and chassis mechanisms, including the drive axle on all-wheel drive models.