Front engine mount cross member
1. Raise the vehicle and place safety posts under the frame.
2. Remove the front axle main gear housing guard.
3. Loosen the bolts securing the crossmember to the frame. Tightening torque 120 Nm.
4. Remove the cross member.
5. Installation is carried out in reverse order.
Automatic transmission support crossmember
1. Raise the vehicle and place safety posts under the frame.
2. Place a temporary support under the automatic transmission.
3. Unscrew the nuts securing the automatic transmission support cushion to the crossmember. Tightening torque 40 Nm.
4. Raise the rear end of the automatic transmission.
5. Unscrew the support cross member fastener to the frame. Tightening torque 95 Nm.
Series 1500 |
Series 2500 |
6. Installation is carried out in reverse order.
Frame braces
1. Raise the vehicle and place safety posts under the frame.
2. Loosen the bolts securing the braces to the frame. Tightening torque 50 Nm.
3. Remove the braces.
4. Installation is carried out in reverse order.
[The material was created based on information from the website: «chevyman.ru»]