Rear Floor Trim Panel (Avalanche/Escalade EXT) (Chevrolet Tahoe 2)

Removal

1. Remove the rear pillar molding.

2. Remove the hinges of the middle door (between the passenger compartment and the cargo compartment).

3. Pull the rear floor trim panel (1) out of the three clips (2).

3. Pull the rear floor trim panel (1) out of the three clips (2).

Installation

4. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Exterior (external elements)

Rear Fender Trim Panel
Front pillar molding
Cargo compartment door opening molding
Rear corner molding
Rear Headliner Molding (Avalanche/Escalade EXT)

Rear pillar molding (Avalanche/Escalade EXT)
Rear pillar molding

See similar articles on the topic of Chevrolet cars:
Removal and installation the rear door trim Chevrolet Aveo T300 (2012-2018)
Rear Floor Panel Extension Chevrolet Captiva 1 (2006-2018)
Removal and installation the rear door trim Chevrolet Cruze 1 (2008-2016)
Removal the rear section of the floor tunnel trim Chevrolet Lacetti 1 (2002-2009)
Removal the rear door trim Chevrolet Lanos T150 (2002-2009)
Instrument panel Chevrolet Niva 1 (2002-2016)
Rear door and tailgate trim Chevrolet Orlando 1 (2010-2018)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)