Removal and installation the cruise control system control unit (Chevrolet Tahoe 2)

1. Unscrew the bracket mounting bolts above the mudguard. Tightening torque 9 Nm.

2. Remove the bracket above the fender liner.

3. Disconnect the connector.

4. Loosen the cruise control unit mounting nuts. Tightening torque 9 Nm.

5. Disconnect the connector.

6. Remove the cruise control unit.

7. Install in the reverse order.

[The article was reprinted from the website CHEVYMAN.RU]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (until 2007)

Registering and synchronizing the remote control transmitter
Replacing the battery in the transmitter
Removal and installation the remote lock control unit
Removal and installation the washer fluid level sensor
Removal and installation the electric washer pump

Removal and installation the cruise control cable
Removal and installation of the electronic unit of the parking system
Removal and installation parking system indicators
Removal and installation the parking system switch
Removal and installation parking sensors

See similar articles on the topic of Chevrolet cars:
Ventilation system with manual control unit Chevrolet Aveo T300 (2012-2018)
Operation of the automatic cruise control system Chevrolet Captiva 1 (2006-2018)
Scheme 12. Cruise control system Chevrolet Cruze 1 (2008-2016)
Schematic diagram of the electronic engine management system with the MR-140 control unit Chevrolet Lacetti 1 (2002-2009)
Heating, ventilation and air conditioning control unit Chevrolet Lanos T150 (2002-2009)
Remote control system for electrical package «Norma» Chevrolet Niva 1 (2002-2016)
System — Cruise control Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)