Replacing the battery in the transmitter (Chevrolet Tahoe 2)

1. Insert a coin into the service hole.

2. Turn the coin.

3. Replace the battery. Battery type is CR2032.

4. Install the battery with the "+" side down.

5. Align the transmitter parts.

6. Squeeze them.

7. Check the functionality of the transmitter.

The source of the article is available on the website ChevyMan

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (until 2007)

Removal and installation the remote lock control unit
Removal and installation the washer fluid level sensor
Removal and installation the electric washer pump
Removal and installation the windshield washer reservoir
Removal and installation the rear window wiper arm and brush

Registering and synchronizing the remote control transmitter
Removal and installation the cruise control system control unit
Removal and installation the cruise control cable
Removal and installation of the electronic unit of the parking system
Removal and installation parking system indicators

See similar articles on the topic of Chevrolet cars:
The battery is not recharging Chevrolet Aveo T300 (2012-2018)
Rechargeable battery Chevrolet Captiva 1 (2006-2018)
The battery is not recharging Chevrolet Cruze 1 (2008-2016)
Starting the engine from another car's battery («jump-starting») Chevrolet Lacetti 1 (2002-2009)
Starting the engine from another car's battery (jump-starting) Chevrolet Lanos T150 (2002-2009)
Replacing the battery of the key with the remote control Chevrolet Niva 1 (2002-2016)
Checking the condition and replacing the battery cables Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)