Removal and installation the sunroof drive electric motor (Chevrolet Tahoe 2)

1. Remove the roof console.

2. Remove the hatch bracket.

3. Disconnect the connector (1).

4. Loosen the screws (2). Tightening torque 6 Nm.

5. Remove the sunroof drive motor (3).

Note: If necessary, after installing the sunroof drive motor, perform the authorization procedure.

6. Install in the reverse order of removal.

[The source of the article is available on the website CHEVYMAN.ru]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (since 2007)

Replacing the battery in the transmitter
Central locking remote control unit
Electric motor for window lift (rear doors)
Removal and installation window lift guides (rear doors)
Electric window lifter motor (front doors)

Authorization procedure for the sunroof drive motor
Removal and installation the sunroof electric drive control switch
Removal and installation the rear door electric drive control unit
Removal and installation the rear door drive motor
Removal and installation the rear door electric drive rod