Removal and installation the sunroof electric drive control switch (Chevrolet Tahoe 2)

1. Remove the roof console (1).

2. Loosen the screws (2).

3. Disconnect the connector.

4. Remove the sunroof electric drive control switch (3).

5. Install in the reverse order of removal.

The source of the article is available on the website CHEVYMAN

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Electrical appliances (since 2007)

Authorization procedure for the sunroof drive motor
Removal and installation the sunroof drive electric motor
Replacing the battery in the transmitter
Central locking remote control unit
Electric motor for window lift (rear doors)

Removal and installation the rear door electric drive control unit
Removal and installation the rear door drive motor
Removal and installation the rear door electric drive rod
Removal and installation the rear door position sensor
Removal and installation the rear door electric drive switch

See similar articles on the topic of Chevrolet cars:
Adjusting the manual transmission control drive Chevrolet Aveo T300 (2012-2018)
Electric sunroof control switch Chevrolet Captiva 1 (2006-2018)
Replacing the electric window control switch unit Chevrolet Cruze 1 (2008-2016)
Adjusting the gearbox control drive Chevrolet Lacetti 1 (2002-2009)
Wiring diagram of the right outside rearview mirror with electric drive Chevrolet Lanos T150 (2002-2009)
Electric window control Chevrolet Niva 1 (2002-2016)
Transfer case control switch (models with electric shift mechanism) Chevrolet Trailblazer 1 (2001-2008, petrol)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)