Front cable
1. Raise the rear of the vehicle and secure it to stands.
2. Loosen equalizer nut (adjusting nut) and separate the front cable from the connector and equalizer.
3. Remove the clips from the frame and remove the cable from the wire bracket.
4. Remove the left panel located under the instrument panel to provide access to the parking brake pedal mechanism.
5. Remove the clip from the end of the cable at the lever (see illustration) and push the cable and sheath through the bracket while pressing on the lug.
11.5. Remove the clamp first (A) with the parking brake lever, and then press the tip (IN) and pull the cable through the bracket
6. Remove the cable sheath from the equalizer and disconnect the cable.
7. Installation is carried out in the reverse order. The cable adjustment operation is described in section 10.
Rear cable
8. Raise the vehicle and secure it on stands.
9. Loosen the equalizer and disconnect the rear cable from the equalizer.
10. Disconnect the cable from the frame bracket by pressing the latch with pliers (see illustration).
11.10. Press on the tip and separate the cable sheath from the bracket
11. Remove the brake drum and brake shoes as described in section 5. Disconnect the parking brake cable from the lever.
12. Using pliers, press the cable sheath latch and pull the cable and sheath through the brake shield.
13. Installation is carried out in the reverse order. Be sure to adjust the cable as described in section 10.