Yaw rate sensor (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Remove the center panel. See section 9G, "Interior Trim".

2. Remove the yaw rate sensor.

Installation procedure

1. Install the yaw rate sensor.

Tighten

Tighten the yaw rate sensor to underbody mounting bolt to 10 N·m (7 lb-ft).

2. Install the center panel. See section 9G, "Interior Trim".

[The original text can be found on the website: ChevyMan.ru]

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Brake system

ESP Switch/DSC Switch
Rear wheel speed sensor
Front wheel speed sensor
Brake modulator assembly
ABS brake system controller

General description and operation of the parking brake system
Parking Brake Adjustment — Rear Disc Brakes
Parking brake indicator light switch
Parking brake lever
Parking brake cable

See similar articles on the topic of Chevrolet cars:
Removal and installation the shock sensor Chevrolet Aveo T300 (2012-2018)
Replacing the pressure sensor Chevrolet Cruze 1 (2008-2016)
Removal the low oil pressure sensor Chevrolet Lacetti 1 (2002-2009)
Checking the crankshaft position sensor and its circuits Chevrolet Lanos T150 (2002-2009)
Induction ignition sensor (before 1995) — checking and replacement Chevrolet Tahoe 1 (1992-2000)
Checking and replacing the coolant temperature sensor Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Captiva 1 (2006-2018)