RFA (Remote Function Activation) Receiver (Chevrolet Captiva 1)

Contents: Removal procedure ↧ Installation procedure ↧

Removal procedure

1. Disconnect the cable from the negative battery terminal.

2. Remove the steering column opening pillar in the instrument panel. See Section 9E, Instrumentation/Driver Information System.

3. Remove the RFA receiver.

4. Disconnect the electrical connector.

Note: Perform SPO reprogramming when replacing RFA receiver.

Note: Perform SPO reprogramming when replacing RFA receiver.

Installation procedure

1. Connect the electrical connector.

2. Install RFA receiver.

3. Install the steering column opening pillar into the instrument panel. See Section 9E, Instrumentation/Driver Information System.

4. Connect the cable to the negative terminal of the battery.

The original article can be found on the resource ChevyMan.ru

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Captiva 1: Equipment and devices

Diagnostics of malfunctions of lock control systems
General description and operation of the remote anti-theft system
Side Window Antenna Block
Central speaker on the dashboard
Door speakers — removal and installation

Front door control and contact switches
Tailgate Control Switch
Tilt sensor — removal and installation
Security alarm sensor (shake)
Anti-theft alarm — removal and installation