Removal procedure
1. Disconnect the cable from the negative battery terminal.
2. Remove the front left seat. See Section 9H "seats".
3. Disconnect tilt sensor connector.
4. Remove the tilt sensor from the bracket by sliding it back.
5. If necessary, loosen the screws and remove the bracket.
Installation procedure
1. Install the tilt sensor bracket and secure it with bolts.
Tighten
Tighten the tilt sensor bracket bolts to 10 Nm (7 lb-ft).
2. Install the tilt sensor on the bracket.
3. Connect the tilt sensor connector.
4. Install the left front seat. See Section 9H "seats".
5. Connect the wire to the negative terminal of the battery.