Rear window wiper lever (Chevrolet Tahoe 2)

Removal

1. Disconnect the washer hose.

2. Remove the wiper arm nut cover.

3. Unscrew the nut securing the lever to the electric motor shaft. Tightening torque 23 Nm.

3. Unscrew the nut securing the lever to the electric motor shaft. Tightening torque 23 Nm.

4. Remove the lever.

Installation

5. Installation is carried out in reverse order.

The article was checked: Vladimir Romannikov

This article is available at russian, bulgarian, belarusian, ukrainian, serbian, croatian, romanian, polish, slovak, hungarian

Share information:

Tahoe 2 and 3: Doors, locks and windows

Rear window wiper motor
Wiper Motor Cover
Windshield wiper lever
Windshield wiper motor and linkage
Washer pump and reservoir

Sunroof — Position adjustment
Roof drainage channel
Sunroof Tie Rods
Sunroof Drain Hose
Sunroof glass

See similar articles on the topic of Chevrolet cars:
Removal and installation the rear door window regulator Chevrolet Aveo T300 (2012-2018)
Rear window wiper/washer Chevrolet Captiva 1 (2006-2018)
Replacing the rear door window regulator Chevrolet Cruze 1 (2008-2016)
Wiring diagram for windshield and rear window wipers and washers (hatchback and station wagon, without rain sensor) Chevrolet Lacetti 1 (2002-2009)
Rear window heating circuit diagram Chevrolet Lanos T150 (2002-2009)
Removal and installation the rear window wiper Chevrolet Niva 1 (2002-2016)
Removal and installation the rear window wiper motor Chevrolet Lumina 1 (1989-1994)

Link in different formats to this page

TextHTMLBB Code

Visitor comments

No comments yet

Tahoe 2 and 3 (2000-2014)